ENFORCER E-921CPQ User Manual

ENFORCER Voice Dialer
6 SECO-LARM U.S.A., Inc.
Programming the Voice Dialer:
The setup mode may only be accessed when the dialer is in standby mode. If no key is pressed
within 15 seconds, the dialer will automatically exit the setup mode.
Setting and Changing the PIN Number
1. Enter the current PIN number (factory preset PIN number is ‘000’), and press the [PROG]
button once. ‘PASSWORD’ will flash on the LCD.
2. Press the [ARM/DISARM] button to accept.
3. Enter a new PIN number (3-6 digits) followed by the [ARM/DISARM] button to confirm.
4. Press the [#/DOWN] or [*/UP] button to select other setup categories or press the [PROG]
button until the programming icons disappear to exit the setup mode.
Example 1 – To store a number with area code 1-214-555-2858 and an office extension 205
(where the called number requires a 2-second pause before the extension): After scrolling to
the desired number location, enter ‘12145552858,’ press the [DEL/PAUSE] button for 2
seconds until the letter ‘F’ appears on the LCD screen, enter ‘205’ and press the
[
ARM/DISARM
]
button.
Note: If the PIN number is forgotten, press and hold the [PROG] button and use a pen or
paper clip to press the [RESET] button located near the battery receptacle cover on the back
of the unit and release. The unit will return to the factory preset PIN number (000). All other
user programmed settings except the date and time will be retained.
Setting Emergency Phone Numbers
1. Enter the PIN number and press the [PROG] button twice or until “MEMORY” flashes on the
LCD screen.
2. Press the [ARM/DISARM] button to accept.
3. Press the [#/DOWN] or [*/UP] button to select one of the number locations 1-5.
Note: The 5 number locations represent the order in which the numbers will be dialed in the
case of an alarm.
4. Enter the number to store including any area codes or dialing prefixes if needed (up to 32
digits, although only the last 16 digits can be shown on the LCD display) using the keypad
followed b
y
the
[
ARM/DISARM
]
button to acce
p
t and store the number.
Note: If needed, a 4-second ‘pause’ can be entered by pressing and holding the
[DEL/PAUSE] button for 2 seconds until the letter ‘F’ appears on the LCD screen. A ‘#’ or ‘*’
can also be entered by pressing, and holding for two seconds, the [#/DOWN] or [*/UP]
buttons respectively. The ‘#’ sign shows as ‘
┘
’ and the ‘*’ sign shows as ‘
└
’ on the
LCD screen.

ENFORCER E-921CPQ Specifications

General

Brand	ENFORCER
Model	E-921CPQ
Category	Security System
Language	English