General procedures for using Engbo Maxi windlasses
Read the operating manual carefully before installing and using the windlass.
Please note that strong forces are involved, so please use the windlass carefully and make
sure, for example, that:
You do not get your fingers caught up in the rope, chain, anchor, rollers or gypsies.
The rope/chain is always under observation when the anchor is being raised.
Everyone on board has been informed of how the windlass functions.
You always operate the winch from a place that provides an unobstructed view of the
anchor while it is being raised. This will help prevent “unpleasant surprises” that may
damage the boat.
You release the switch for a little while if the windlass is straining to raise the anchor.
When the boat has started moving backwards, you can start the windlass again. This
will make it easier for the windlass to operate, and it will use less power.
If the anchor is stuck on the seabed: Release some rope and make it fast to a cleat on
the boat. Then use the boat engine to free the anchor. Once the anchor has been freed,
use the windlass in the usual manner.
The windlass can run for max. 3 minutes at normal load.
The anchor must always be secured to the boat while the boat is travelling. Use the
securing lines supplied.
Disconnect the power to the windlass once the boat is underway.
Children must not operate the windlass.
Negligent use can result in unnecessary damage.
Always make sure the battery is well charged when using the windlass. Always have
the motor running when the windlass is in use.
The windlass features electronic overload protection. If necessary, let the winch cool
down for 15–20 min. and then try again. In the event of an emergency, you can
override the overload protection by disconnecting and then reconnecting the main
power switch for the windlass.
Engbo AS accepts no liability for injuries or damage resulting from the use of the
windlass.
IMPORTANT!
Always have the boat engine running while the windlass is in use.
Always disconnect the power from the windlass when it is not in use.
Make sure to fit and use the windlass and its accessories in such a way as to
prevent injuries to people and damage to the boat and/or its surroundings.
Installation must be done or checked by trained personel with special
knowledge regarding high current and low voltage.
Faulty installations or connections of any components to the windlass will
render all warranty given by Engbo void.
To avoid overload when anchoring, the anchor line/chain must be secured
properly.
If the anchor has got stuck at the seabed, if possible, pull the anchor from
different directions by moving the boat in different positions.
When doing this, it is recommended to fix the anchor line in the cleat to avoid
overload.
To Next Page
Loading...
