ENGBO AS – et selskap i Engbo-gruppen
BESØKSADRESSE: Wirgenesvei 7, 3157 Barkåker POSTADR: Postboks 2288 Postterminalen, 3103 Tønsberg
E-MAIL: support@engbo.no WEB: www.engbo.no TLF: +47 33 00 31 50 FAKS: +47 33 00 31 60
The Maxi 38 is designed to be fitted hanging below a
horizontal surface – for example, by fitting the windlass
below the deck or the bathing platform, as shown in the
picture to the left.
The Maxi 38 is available with the line wheel on the right or
left-hand side of the windlass, as seen from the rear.
Fit, for instance, the windlass together with a “gooseneck”
(68-00004), so the windlass fixing bolts are screwed into
the gooseneck from below with the platform or deck in
between.
NB Make sure to position the windlass correctly in relation
to the rope roller so that the windlass line wheel and the
roller are in line.
Use the gooseneck as the template for marking the
fixing holes for the windlass.
NB It is important to ensure that there is sufficient space
between the anchor and the gooseneck, to prevent the
line splice getting stuck in the gooseneck.
Run the line via the line wheel on the windlass,
down through the rope/chain guide and under the
line wheel. Use the windlass to wind it up.
The rope is collected below the windlass. It is
important to ensure that there is sufficient space to
prevent the rope bunching below the windlass.
There must be at least 50 cm of free space below
the windlass, and the area where the rope is stored
must measure at least 40 x 40 cm.
To Next Page
Loading...
