SGII
– Doriot One - Piece Handpiece
Your unit may be equipped with the SGII – Doriot One-Piece Handpiece instead of the E-TYPE LOW
SPEED HANDPIECE, in this case use the following instructions.
The speed of the polishing head is proportional to the amount of pressure applied to the foot-switch
pedal. Use low pressure to maintain a low speed.
SGII – Doriot One-piece Handpiece
Technical Facts
SGII: Doriot One-piece Handpiece
Maximum RPM: 20,000 min
or 5,000 max
Attachment: accepts both handpiece burs and Doriot / U-type
attachments
Air Requirements: Clean filtered moisture free air with recommended
pressure of at least 45 psi. Do not exceed 60 psi.
Operation
2 1
Removing handpiece bur or Doriot attachment from Doriot Handpiece: Hold the handpiece in
the left hand, depress housing ring toward the body of the handpiece while twisting ¼ turn to the right
to open the chuck.
**Push then Pull the handpiece bur or attachment and remove from the chuck.
Forward / Reverse Speed:
Forward: Twist change ring fully clockwise
Reverse: Twist change ring fully conter-clockwise
–In mid position, handpiece will not
operate
19
To Next Page
Loading...
