WATER TANK INSTRUCTIONS
PT-1 Water Tank
PUMP-UP WATER BOTTLE DIRECTIONS:
1. Remove pump / cap assembly by turning it counter-clockwise.
2. Fill tank with distilled water or medicated solution up to the “FILL LINE”. Do NOT fill beyond this line.
3. Replace pump / cap assembly and tighten securely.
4. Pressurize tank by pumping it approximately 30 - 40 times (depending on the amount of liquid used).
Insert the male quick disconnect at the end of the water hose into female quick disconnect provided on
tank.
5. Release air pressure by PULLING and TURNING the red pressure relief valve located near the top of the
bottle.
If bottle is not equipped with a pressure relief valve, relieve pressure by unscrewing cap / pump assy.
until a hissing sound can be heard. Wait till hissing stops to safely remove cap / pump assy.
Notice
Tanks may or may not be supplied with a pressure relief valve. Those that do not are designed to “bleed off”
pressure from the pump and cap assembly when removed (unscrewed).
The presence or absence of a pressure relief valve does not otherwise affect the function of the pump.
Notice: Tank hardware, styles, accessories, etc. are subject to availability and may change without
notice. Pressure relief valves, oil holes, etc. may or may not be available on all tanks.
27
To Next Page
Loading...