enphase IQ Combiner 5

Section F
Operation
Site commissioning
1. Launch the Enphase Installer App and start System activation.
Launch the Enphase Installer App, create an activation for a new
system, and enter the required information to complete system
activation.
2. Add Devices and Arrays to the system.
This step is used to enter the unique serial numbers of all devices
present on-site. It is recommended that you enter the serial number
by scanning the barcode/QR code.
• Tap Devices and Array on the home page.
• Add the total number of devices to be installed in your system.
• Scan device serial numbers through bar code or QR code in
respective device sections. Use your device’s camera to scan
serial numbers or enter the serial numbers manually. Manual
entry should be used only when you are not able to scan the
bar code or QR code of any device.
• After scanning microinverters, you can use Array Builder
to assign your scanned microinverters to an array or
build an array manually. This step can be completed post
commissioning as well.
3. Setting site conguration and tari settings.
Go through the Enphase Installer App ow to set up site
conguration and tari settings. For grid-forming systems, site
congurations enable selecting the backup type, setting EPC limits,
and conguring auxiliary contacts on the IQSystemController.
IQ Combiner 5/5C Quick Install Guide39