About This Guide xiii
About This Guide
This guide provides information necessary to install and set up the Matrix C1 Series C1H124-48
and C1G124-24 devices and available options.
For information about the Command Line Interface (CLI) set of commands used to configure and
and manage the C1H124-48 and C1G124-24, refer to the Enterasys Networks™ Matrix C Series
Configuration Guide.
For information about connecting optional redundant power source, refer to the Enterasys
Networks™ Matrix C Series Redundant Power System Installation Guide.
WHO SHOULD USE THIS GUIDE
This guide is intended for a network administrator responsible for installing and setting up the
device.
NOTE: In this guide, the following terms are used:
• Device, unless noted differently, refers to both the C1H124-48 and C1G124-24.
• Mini-GBIC (Mini-Gigabit Interface Card) refers to an optional small form interface
module that plugs into the fixed front panel Mini-GBIC slots.
Important Notice
Depending on the firmware version used in the C1H124-48 and C1G124-24, some features
described in this document may not be supported. Refer to the Release Notes shipped with the
device to determine which features are supported.
ELECTRICAL HAZARD: Only qualified personnel should perform the installation
procedures in this guide.
To Next Page
Loading...
