Enterasys C1H124-24 - Mini-GBIC with MT-RJ Connector (C1 H124-48 Shown)

Installing Optional Mini-GBICs
Hardware Installation 3-3
To prepare and install a Mini-GBIC, proceed as follows:
Preparation
Before installing the Mini-GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC from the antistatic packaging.
2. Remove the Mini-GBIC from the packaging.
3. If there is a protective dust cover (see Figure 3-1,
) on the Mini-GBIC port, do not remove it
at this time.
Installation
To install a Mini-GBIC, refer to Figure 3-1 or Figure 3-2, and proceed as follows:
1. Hold the Mini-GBIC
with its top side facing up and its 7-pin edge connector facing the
port slot
.
2. Carefully align the Mini-GBIC
with the port slot .
3. Push the Mini-GBIC
into the port slot until the Mini-GBIC “clicks” and locks into place.
Figure 3-1 Mini-GBIC with MT-RJ Connector (C1H124-48 shown)
Mini-GBIC (MGBIC-MT01) Port slot
Mini-GBIC, top side Mini-GBIC, protective dust cover
7-Pin edge connector (insertion side) Release tab
Â
Á
À
Å
3831_01_02
CPU RPS 149
51
250 52
1
2
52
50
49
51
Ã
Ä