Setting Up the Matrix N7 Chassis
3-12 Matrix N7 Chassis Setup
Figure 3-7 Installing the Power Supply Module(s)
After completing the power supply and module installations, the Matrix N7 chassis is ready to be
powered up. Proceed to Section 3.3 for instructions to power up the chassis.
3.2.5 Removing a Power Supply
To remove a 7C203-1 power supply, refer to Figure 3-8 and proceed as follows:
1. Attach the anti-static wrist strap as described in Section 3.2.3.3 before handling the power
supply module.
2. Set the power supply 0/| Power switch
➀ to 0.
➀
Mandatory power supply installed in slot PS1
➃
Slotted screw
➁
Power supply handle
➄
Blank plate covering slot PS2
➂
Card guides
NOTE: To install the modules, refer to the module installation guide for the installation
instructions. Before you power up the Matrix N7 chassis, it is recommended that you
complete the installation of the modules in the chassis.
CAUTION: Always set the 0/| power switch to 0 before removing a power supply from
the chassis.
50/60Hz
LINE 2:
100-125V~12A
200-240V~6A
50/60Hz
LINE 1:
100-125V~10A
200-240V~5A
POWER FAN
PS1
À
Ã
Á
Â
Ä
To Next Page
Loading...
Need help?
General
