Entron iPAK2 Technical Manual

Section 14 Tutorials 91
07 Resetting faults
Fault conditions and error messages can be reset in several ways.
WSP3
LOWMAINCURRENT
From the Status screen press
‐‐0aprog0
‐‐10.1ka5.80kn
‐‐0a~30.5%
NetFlash
Use to select the Metrics window then select the
reset button
Discrete input
Input Pin number Description
Reset fault P2.15 This input resets the Fault output and clears the status
messages. Only momentary application is required
(minimum time 40ms).
The discrete I/O is described in Section 4 Discrete I/O.
Bus input
Input Channel Address Description
Reset fault Bit 6 %QX0.6 This input resets the Fault output and clears the status
messages. Only momentary application is required
(minimum time 40ms).
The bus I/O is described in Section 5 MODBUS I/O.

Entron iPAK2 Specifications

General

Brand	Entron
Model	iPAK2
Category	Controller
Language	English