Entron iPAK2 - Seam Welding

Section 12 Confi
g
uration 54
Seam welding (extended feature)
iPAK2 can be used for seam welding applications. The seam program parameters provide a flexible sequence
that works in conjunction with the inputs and outputs to produce several different types of seam weld e.g.
 continuous seam
 seam pulsation
 seam modulation
 seam pre-heat
 roll-spot
The parameters are described in Section 6 Weld control and can be adjusted during the weld. Intervals that are
not required may be set to 0.