Entron iPAK2 Technical Manual

Section 1 Introduction 5
Introduction
The iPAK2 controller is suitable for MFDC spot, projection, roll-spot, seam and multi-welding welding
applications.
The controller supports:
 pre-heat, main heat and post-heat intervals
 force profiles
 multi-gun, multi-air valve applications
 multiple electrodes
The iPAK2 has multiple communication and control options and can be configured by a number of
programming options. The Ethernet port supports simultaneous programming and control via a single
physical cable.
Short-circuit proof outputs and a guided-contact pilot relay provides enhanced safety. Connection to the
power system is via a single ribbon cable. Analog inputs and outputs can be used to drive a proportional
air regulator valve for force control.
Operation in Standard mode provides a basic set of features for simple applications. Extended mode
adds advanced features for more demanding applications. Choose between Standard or Extended
features (Section 12 Configuration). The iPAK2 must be restarted after changing this setting.

Entron iPAK2 Specifications

General

Brand	Entron
Model	iPAK2
Category	Controller
Language	English