Section 15 Appendix 92
Appendix
Updating the firmware
The functionality of iPAK2 is determined by firmware stored in reprogrammable memory. iPAK2 has three
memories:
Memory Description
A Memory A
B Memory B
BIOS BIOS memory
The firmware can be transferred to one or more of the memories and then activated when iPAK2 starts. In this
way it is possible to retain different firmwares and activate them without having to reprogram iPAK2. When new
features become available NetFlash is used to update the firmware.
Initialise NetFlash and select the target iPAK2 as described in Section 13 Programming.
Select the Flash Programming tool . The following screen is shown:
Connect to the iPAK2
Start transfer to the iPAK2
Change the active memory
Select the flash file
To Next Page
Loading...
