connection.
d. Click Configuration and wait for success.
Note: If the setting is not successful, wait 5 seconds. Click Configuration again
and check that the EVT400 is as close to the router as possible.
Option 2. Use computer to configure WiFi
1. Go to your computer’s WLAN setting. Connect a network of the same name
as your EVT microinverter Serial Number.
2. Use a browser to open the webpage: http://10.10.100.254 . Log in to the
account with the credentials below. Username: admin Password: admin
3. Click "STA Setting" for the relevant configuration, and click "Scan" to scan
the WIFI.
4. Select the current wireless network, and press "OK".
To Next Page
Loading...
