Enviro CFR User Manual (English)

Other manuals for Enviro CFR

Questions and Answers:

D
Douglas ScottSep 9, 2025
Why Enviro CFR Touch terminals heater does not operate?
- T
  Tara CrawfordSep 9, 2025
  If the heater in your Enviro Touch terminals does not operate, consider these potential causes: * No Power: Check the disconnect. * No Control Voltage: Check the transformer and transformer fusing (if applicable) and replace if necessary. * Blown Fuse: Replace the fuse. * Open Limit (primary or secondary): Replace the limits or reset as applicable. * Airflow Incorrect Direction: Check the sensing tube, red tube = high and black tube = low, rotate if needed. * Low External Static Pressure: Increase airflow to obtain a minimum of .1 in. w.c. external static. * Damaged elements: Check for open or damaged elements and replace as necessary.
B
bwattsSep 12, 2025
How to solve low coil capacity in Enviro CFR?
- C
  Caroline SmithSep 12, 2025
  Low coil capacity in Enviro Touch terminals might be due to: * Incorrect airflow: Check the fan’s operating conditions. * Incorrect GPM: Check water pumps, valves, and lines for obstructions. * Dirty coil fins: Clean the coil fins. * Dirty filter (where applicable): Replace the filter. * Incorrect water temperature: Provide the proper water temperature.
D
Douglas RogersSep 13, 2025
What causes low or high temperature rise in Enviro CFR Touch terminals?
- B
  Benjamin CrossSep 13, 2025
  Low or high temperature rise in Enviro Touch terminals could stem from: * Incompatible Thermostat or Controller: Check the wiring. * Problems with Additional Stages: Check the location of the thermostat; it might be installed in a “too hot” or “too cold” location. Also, check the heat outputs on the controller. * Incorrect CFM: Check for blocked ducts or the location of the heater.
A
Andrea NicholsSep 14, 2025
What to do if Enviro CFR heater with SSR does not operate?
- S
  Samuel Goodwin DDSSep 14, 2025
  If the heater with SSR in your Enviro Touch terminals does not operate, check: * Incorrect Signal Applied: Verify the signal input. * Interface Board Fuse Blown: Replace the fuse.

Enviro CFR Specifications

General

Brand	Enviro
Model	CFR
Category	Touch terminals
Language	English

Enviro CFR Installation Operation & Maintenance

Table of Contents

Other manuals for Enviro CFR

Questions and Answers:

Enviro CFR Specifications