24
Initial Installation
QUALIFIED INSTALLERS ONLY
exhaust RestRictoR:
1
2
3
4
Vent Length
Restrictor
Setting
10’-20’
(3.05-6.1m)
1
20’-30’
(6.1-9.1m)
2
30’-40’
(9.1-12.2m)
3
This replace has an internal exhaust restrictor that can adjusted
externally while the replace is in operation. Depending on the length
of venting required for installation this may need to be adjusted.
The restrictor is accessed from the front of the replace through the
discharge opening as shown above. Using a 3/8” socket on a 10”
long extension, rotate the restrictor COUNTER-CLOCKWISE until the
required setting is inline with the nger catch. Refer to Table 5 for the
required restrictor setting.
Note: The restrictor is set to setting #1 from the factory.
Figure 27: Exhaust Restrictor
Table 6: Restrictor Settings
FINGER CATCH
instaLLation instRuctions:
1. Plan your installation and clearances
to combustibles. The EX32 may be
installed and vented into any solid
fuel replace that has been installed
in accordance with the National,
Provincial/State and local building
codes and has been constructed of
non-combustible materials. Also refer
ClearanCes to CombustIbles section.
2. Remove door. See maIntenanCe anD
serVICe - glass Door remoVal.
2ft (0.6m)
Minimum
3ft (0.9m)
Minimum
Within
10ft (3m)
Roof ridge or
any other portion
of a building
Figure 28: Roof Clearances.
instaLLing the ex32:
• Remove the crate and packaging from the appliance and check to make sure there is no damage.
Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is found,
please report it to your dealer as soon as possible.
• Carefully clean the replace and ue before installing the stove. Failure to do so may result in fumes
or soot being blown into the room and may cause a re leading to death or serious injury.
3. Remove packaged log set and all wrapping material from the stove. Remove wrapping material from
the log set and check for any damage. If damage is observed, do not use unit and contact your local
dealer.
To Next Page
Loading...
Need help?
General
