EOS E-Cool Wall B - Machine Produces; Switching off the Machine; Decommissioning

30
EN
Decommissioning
• Close the water supply at customer's site.
• Disconnect the ake ice machine from the
mains.
• Remove the mains plug.
• Disinfect and empty the water circuit.
• Disconnect all connections.
• Release the water supply hose.
• Release the connection for the supply and
return lines of the cooling circuit.
• Release the hose of the supply and return
line connections.
• Release and remove the hood from the hou-
sing.
• Verify that there is no water in the ice machi-
ne.
• Dry the ake ice machine with a soft cloth
Switch o the machine
• Unplug from the mains
Machine produces
The flake ice machine continuously produce
ake ice which drops into the ice duct.
Ice feeding is monitored by a sensor at the ice
duct. If the maximum filling level has been
reached, the flake ice production is stopped
automatically.
Flake ice production starts automatically when
the ice level in the duct reduces.
Note!
As the evaporation temperature is still too high
initially, you should wait for about 10 minutes.
The ice only has the required consistency after
about 10 minutes.