EP Equipment CQD15S-E - Troubleshooting; Faults and Actions

39
6.Troubleshooting
This chapter is designed to help the user identify and rectify basic faults or the results
of incorrect operation. When locating a fault, proceed in the order shown in the table.
Fault
Possible cause
Action
Truck does
not start.
• Battery connector not
connected.
• Key switch in “OFF” position
• Battery charge too low
• Faulty fuse
• truck in charge mode
• Check the battery connector and
connect if necessary.
• Set key switch to “I”
• Check battery charge, charge
battery if Necessary
• Test fuses
• Interrupt charging
Load can
not be
lifted
• Hydraulic oil level too low
• Excessive load
• Check the hydraulic oil level
• Note maximum capacity (see
data plate)
If the fault cannot be rectified after carrying out the remedial procedure, notify the
manufacturer ’ s service department ,as any further troubleshooting can only be
performed by specially trained and qualified service personnel.