EPH Controls CP4 V2 - Page 49

49
RFRP
V2
OpenTherm® Instructions
This function allows the installer to activate or deactivate DHW target
temperature control from the thermostat. This menu is only available
when the thermostat is connected to OpenTherm®
This function allows the installer to congure the OpenTherm®
parameters.
To access the menu please enter the password “08” by pressing
+
or
.
Press
to conrm.
The parameters that can be set are outlined in the table on the next
page 50.
P11 DHOP
P12 Set OpenTherm® Parameters