EPH Controls CP4 V2 - Mounting & Installation

9
RFRP
V2
Room Thermostat CP4
V2
Mounting & Installation
Caution!
 Installation and connection should only be carried out by a qualied
person.
 Only qualied electricians or authorised service sta are permitted to
open the thermostat.
 If the thermostat is used in a way not specied by the manufacturer, its
safety may be impaired.
 Prior to setting the thermostat, it is necessary to complete all required
settings described in this section.
This thermostat can be mounted in the following ways:
1) Directly mounted on wall.
2) Free standing - Stand Included.
Note: For accurate temperature control it is recommended to mount the
thermostat as per the installation drawing on Page 11.
*If installing multiple CP4
V2
/ CP4
V2
-HW please see page 15 & 50.
Note: If installing multiple CP4
V2
/ CP4
V2
-HW please ensure to keep a
minimum of 25cm distance between receivers.