60
RF1B Wireless Receiver CP4
V2
On the RF1B receiver:
Hold
Manual
&
Connect
for 5 seconds.
The Hub LED will illuminate. The receiver is now a HUB.
Hold
Connect
on the RF1B until RF LED ashes.
On the GW04 Gateway:
Hold the RF Connect button
until RF LED ashes.
The gateway & receiver will stop ashing. Paring is now complete.
The white RF light on the GW04 will stay illuminated.
Pairing your RF1B Receiver to your GW04 Gateway
Note: Your CP4
V2
can be controlled remotely via the EMBER app with the addition of a GW04
Gateway.
Note: If you are connecting multiple receivers to a GW04 Gateway, please ensure that all branch
receivers are connected to the hub receiver. There can only be 1 hub receiver in a system. Allow
5 minutes for all receivers to synchronise with the hub receiver before connecting the gateway
to the EMBER App. See page 52 & 53.
Ensure that your RFRP
V2
thermostat(s) are paired to your RF1B
receiver(s). Ensure that the receiver you’re connecting to the boiler is
set up as a Hub receiver:
To Next Page
Loading...
