SmartROC T35/T40 4 Safety Precautions
18 No: 5966599819.1.5966707083 en-US
• Avoid clogging the compressor with paint, carbonized oil, or dirt, which could disrupt
compressor operation.
• Check pressure and control gauges regularly and replace with new ones when they
can no longer measure the permitted values.
• Position the machine so that no dust blows against it.
• Close the compressor air outlet valve before connecting or disconnecting a hose.
Make sure that the hose is fully-vented before disconnecting.
• Make sure that the open end of the hose or air line is steady before blowing com-
pressed air from the other end. Impact from a loose end could cause injury or damage.
• Do not use external force on the air outlet valves, for example, pulling the hoses.
• Do not install additional equipment directly on an air outlet valve, for example, a water
separator or a lubricating device.
• Use distribution lines, hose couplings, clamps, and air hoses which are of correct di-
mension and suitable for the working pressure. Do not use damaged or worn hoses.
• Make sure that there is no pressure before removing the oil filler plug.
To Next Page
Loading...
Need help?
General
