Page 24
Notes:
1. Please remember the password. The default is ‘000000’.
2. Tip Message will popup only when input wrong. If right, there will be no tip.
Default Set
In this interface, user can restore default parameters.
Click to enter setting mode’, use to
moving cursor, if select ‘Yes’, and press , all
parameters will be recovered to default, and saved. The interface will restore to
‘Browse mode’. If select ‘No’, remain current parameters.
Note: The password will not be changed in this default set. Please refer to Password
introduce.
Prompt Message
In any interface, Prompt Message will popup once
warning event occurs as below: OVD, UVW, LVD,
Current Err, Over Current, Over Temp or PV OVD,
press any key to quit. Inspecting it carefully is
recommended in case that some potential hazard occurs.
In setting mode, if click , ‘Modify OK’ will popup,
it will disappear and return back to ‘Browse mode’
after one second, else click to ‘Browse mode’
without Prompt Message’ popup.
For the Event explanations, please refer to Annex 1!
To Next Page
Loading...
