Printing
l The font selected by the control panel does not print.
Your software may be overriding your panel setting. Check
the font setting in your application program.
l The wrong characters are printed.
._
The wrong character table or the wrong international
character set may be selected. Check the DIP-switch
settings. See page 3-8.
The print position is not what you expected.
l Printing starts too high or too low on the page.
Adjust the top margin set by your application software.
Use Micro-feed to adjust the print position.
l All the text is printed on the same line.
Set DIP switch 2-4 on so that the printer automatically
adds a line-feed code to each carriage return.
a
The text is printed with an extra blank line in between.
-
Two line-feed signals are being sent. Set DIP switch 2-4
off.
-
l The page length does not match the length of your
continuous paper.
Change the page-length setting with DIP switches 2-1 and
2-2. See page 3-8.
-.
Check the page length set by your application software and
-
adjust it if necessary.
6-6
Troubleshooting
To Next Page
Loading...
