Testing the Printer
Before connecting your printer to a computer, use the built-in
self-test function to see that the printer is working properly.
Plugging in the printer
1. Make sure the printer is turned off.
2.
Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your electrical
outlet.
CAUTION: If the rated voltage and your outlet voltage
do not match, contact your dealer for assistance. Do not
plug in the power cord.
3.
If the power cord is not attached to the printer, connect it to
the AC inlet on the printer’s rear panel.
4. Plug the power cord into a properly grounded electrical outlet.
_
1-10
Setting Up the Printer
To Next Page
Loading...
