Epson 1170 - Adjusting the Loading Position

Micro Feed
2. While holding down the ALT button, press the LOAD/EJECT
button to feed the paper forward or press the LF/FF button to
feed the paper backward, as indicated by the arrows above the
buttons.
Adjusting the loading position
The loading position is the position of the paper after it is
automatically loaded by the printer. If your printing is too high or
low on the page, you can change the loading position with the
micro-feed feature as follows:
1. Make sure the printer is turned on.
2. Load either continuous or single-sheet paper (load continuous
paper by pressing the LOAD/EJECT button). The MULTI-PART
light begins to blink.
Note: You can adjust the loading position only while the MULTI-
PART light is blinking.
3-14
Using the Printer