Using continuous Paper
Adjusting the top-of-form position
The top-of-form position is the position the printer feeds the
paper to when it loads the paper or performs a form feed. This
position is important because it determines where the printing
begins on the page.
You may need to adjust the top of form to a certain position for
printing on ready-made forms. To do this, see Adjusting the
loading position on page 3-14.
Removing continuous paper from the pull tractor
1. Tear off the printed document or excess paper at the tear-off
edge.
2.
Hold the LF/FF button to feed the continuous paper forward to
be ejected.
Note: When you are printing with the pull tractor, do not use
the TEAR OFF and LOAD/EJECT buttons.
Paper Handling
2-21
To Next Page
Loading...
