Using Continuous Paper
6. Open the sprocket covers and fit the holes of the paper over
the sprocket pins.
7. Close the sprocket covers.
8. Adjust the right sprocket unit to remove any slack in the
paper; then lock it in place.
9. Attach the paper guide in the flat position. Then slide the edge
guides to the center of the paper’s width.
10. Turn on the printer.
11. Make any adjustments to the loading position with the micro-
feed feature, as described in chapter 3.
12. Install the printer cover.
CAUTION: Use the knob on the left side of the printer
only to clear paper jams when the printer is off.
Otherwise you may damage the printer or lose the top-
of-form position.
2-20
Paper Handling
To Next Page
Loading...
