7-6
Maintenance and Troubleshooting
R4C0910
Rev. C
A5 size TRBLE.FM
1/12/00 Pass 3
L
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Error indicator
When an error occurs, the scanner stops operating and the
ERROR
and
READY
lights indicate the error type as described below.
Command error
The scanner has received incorrect commands from your
scanning software.
When this error occurs, try to rescan the document. The scanner
returns to normal when it receives correct commands. Normally
you do not need to reset the scanner when this type of error
occurs.
Interface error
The interface setup is wrong or the scanner is not properly
connected to the printer.
When this error occurs, check the interface connection and then
push the
P
operate button to turn the scanner off and then back
on again to reset it.
Fatal error
This type of error indicates one of the following problems:
❏
The fluorescent lamp needs to be replaced.
❏
The transportation lock lever is not released.
ERROR Light READY Light Error Type
On On Command error
Flashing Off Interface error
Flashing Flashing Fatal error
Off Off Option error
To Next Page
Loading...
