2-6
Setting Up the Scanner
R4C0910
Rev. C
A5 size SETUP.FM
1/12/00 Pass 3
L
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Plugging in the Scanner
1. Make sure that the scanner is turned off. The scanner is off
when the
P
operate
button is raised (not depressed).
2. If the power cord is not attached to the scanner, connect it to
the AC inlet on the back of the scanner, and plug the other
end into a properly grounded electrical outlet.
c
Caution:
It is not possible to change the scanner's voltage. If the label on
the back of the scanner does not show the correct voltage for your
country, contact your dealer. Do not plug in the power cord.
To Next Page
Loading...
