Epson 1600 - Connecting the Scanner

2-18
Setting Up the Scanner
R4C0910
Rev. C
A5 size SETUP.FM
1/12/00 Pass 3
L
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Connecting the scanner
To connect the scanner to your computer or USB hub:
1. Connect one end of the cable (Type B) to the USB port on the
back of the scanner.
2. Connect the other end of the cable (Type A) to the USB port
on your computer, or USB hub.
Note:
❏
USB cables enable you to connect the scanner whether your
computer is on or off. If you connect the scanner while your
computer is on, the “Add New Hardware Wizard” dialog box
(Windows) or a message telling you that the scanner driver needs
to be installed (Macintosh) will appear. When this happens, follow
the instructions in Chapter 3, then install the software.