Epson 440 - Page 122

Stylus Color 600 Service Manual
Rev. A
5-1
2
Symptom Condition Cause Checkpoint Solution
Printing is
abnormal.
Printing is not
execute.
IC7 is dead. Check the trapezoidal
waveform at 3-pin of Q7
on C200main board.
Replace IC6,
Q7, or Q9.
IC2 is dead. Check the control signal
of trapezoidal from IC2.
(at 80 pin of IC2)
Replace IC2.
Paper feed
operation is
abnormal.
Paper feed
motor does not
work.
IC2 is dead. Check the output
waveform of at 55, 56,
57, 58 pin of IC2.
Replace IC2
IC15 is dead. Check the output
waveform of at 6, 7, 8, 9
pin of IC15.
Replace IC15
Table 5-7. Repair of the C200 Main Board
Table 5-8. Repair of the C200 Main Board(Con.)