Epson 890 - Page 3

Also, the options on page 3 of your system’s Setup program
now support your system’s capabilities more easily. The
following table lists these Setup options:
Setup page 3 options
Setting
Internal Cache
External Cache
Serial Port
Options
Enabled*
Disabled
Enabled
Disabled*
3F8h*
2F8h
3E8h
2E8h
Disabled
Description
Controls the processor's Internal cache
operation
Controls the processor's external cache
operation when external cache is installed
Assigns the serial part address
Serial Part 2 3F8h
2F8h*
3E8h
2E8h
Disabled
Assigns the part address for the
fax/modem or lrDA device, when Installed
Parallel Port 278h*
378h
3BCh
Disabled
Controls the parallel port operation
Audio I/O 220h*
230h
240h
250h
Identifies the l/O setting the audio card
uses
Audio RQ 5
7
9
10
Identifies the IRQ setting the audio card
uses
Pointing Device
Block DE
Serial 2
Enabled*
lets you disable the built-h touchpad, In
Disabled
case you connect a serial mouse
Enabled
Enables support for block mode transfers.
Disabled*
if your turd disk drive supports it
Fax/modem
Lets you define serial Port 2 as either the
IR*
optional Fax/modem or lrDA interface
* Default setting
** Autodetects ECP or EPP devices when connected and turned on at system
start-up
Copyright 1995 by Epson America, Inc.
400532600
Torrance, CA USA 9/95