Status and Error Messages
You can see the printer’s status and error messages on the LCD panel. For more information, see
“Status and Error Messages” on page 91.
Canceling Printing
Press the W Pause/Cancel button on the printer’s control panel.
To cancel a print job before it is sent from your computer, see “Cancelling a Print Job” on page 41.
Printing in the PostScript 3 Mode Problems
The problems listed in this section are those that you may encounter when printing with the PostScript
driver. All procedural instructions refer to the PostScript printer driver.
The printer does not print correctly in the PostScript mode
Cause What to do
The printer’s emulation mode setting is incorrect. The printer is set to the Auto mode by default, so that it can
automatically determine the encoding used in the received print
job data and select the appropriate emulation mode. However,
there are situations where the printer cannot select the correct
emulation mode. In this case, it must be set manually to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See “Emulation Menu” on page 66.
The printer’s emulation mode setting for the interface
that you are using is incorrect.
The emulation mode can be set individually for each interface
which receives print job data. Set the emulation mode for the
interface you are using to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See “Emulation Menu” on page 66.
Epson AcuLaser C9300 Series User's Guide
Troubleshooting 169
To Next Page
Loading...
