Epson AcuLaser CX-11N/AcuLaser CX-11NF Field Repair Guide 9/9/05
Printer Component, Software Item, LCD Display, Printer Button Page 16.
EEPROM Initialization
When the EEPROM is initialized, all counters printed on the Engine Status Sheet are zeroed except the 2nd BTR
Counter. For a detailed listing of counters initialized, refer to the AcuLaser CX11/CX11F Service Manual Chapter 6,
Table 6-3.
To initialize the EEPROM:
1. Depress the Color, Reset, and Left Arrow buttons while powering the CX-11 on. Keep the buttons
depressed until “FORMATTING” is displayed in the bottom left corner of the LCD Panel.
2. When formatting is completed, the LCD display will prompt you to input the Country, Language, and Date & Time
information.
Panel Settings Initialization
This function sets all Selectype settings back to the factory default.
To initialize the Panel Settings:
1. Depress the Reset button while powering the CX-11 on. Keep the Reset button depressed until “SELECTYPE
INIT” is displayed in the upper left corner of the LCD Panel.
RAM Check All Areas
This function will perform a test of all RAM in the CX-11. There is no operational nor visual indication that the test is
being performed unless an error occurs. Performing a RAM Check adds approximately 10 seconds to the Power On
Diagnostic (POD) time.
To initiate the RAM Check All Areas test:
1. Depress the Color, Up Arrow , Left Arrow , and Right Arrow buttons simultaneously while powering
the CX-11 on.
manuals4you.commanuals4you.com
To Next Page
Loading...
