42
8Appendix
Installing the Touch Unit and Control Pad
For details on installing the Touch Unit and Control Pad for your product (if applicable), see the
documentation that came with your projector.
Using the Easy Interactive Function
After you install your BrightLink model (and the Touch Unit, if applicable), you need to perform calibration to
align the positions of the cursor and your interactive pen(s) (and finger, if the Touch Unit is installed). See the
projector’s online User’s Guide or Start Here folder for detailed instructions.
In order to use the Easy Interactive Tools software, you must first install the software on your computer. OS X
users also need to install a driver that enables pen or finger touch interactivity to work. Both software
programs are included with the BrightLink projector.
For details, see the online User's Guide or visit:
U.S.: www.epson.com/support/brightlinkdownloads
Canada: www.epson.ca/support/brightlinkdownloads
Latin America: www.epson.com.jm/support
Correcting the Image Shape on a Curved Screen
If you are projecting on a curved screen, adjust the Arc Correction setting to correct the image shape.
1. Press the [Menu] button on the remote control or control panel.
2. Select Settings.
3. Select Geometry Correction.
4. Select Arc Correction.
5. Select Arc Correction.
6. Select the area that you want to correct.
Touch unit installation requires a projection surface that is flat, smooth, and unwarped
with no more than 0.2 inch (5 mm) of unevenness in any direction on the screen
surface.
Remote Control Control Panel
To Next Page
Loading...
