Epson DS-575W II User Manual

132
Light status Condition/solution
The ! error light is flashing
slowly
A paper jam or a double feed has occurred. Remove any paper loaded
in the input tray. If the light continues to flash, a scanner error may have
occurred. Turn the scanner off and then back on again. If the error
continues, contact Epson for support.
The ! error light is on The scanner cover is open. Make sure the scanner cover is closed and
there is no jammed paper inside.
The following lights are
flashing quickly:
• ! error
• ready
• AP mode (DS-575W II)
• Wi-Fi (DS-575W II)
A fatal error has occurred. Try the following:
• Check the scanner connection to your computer to make sure it is
secure.
• Turn the scanner off and then back on again. If the error continues,
the scanner may be malfunctioning. Contact Epson for support.
The ready light is off and
the following lights are on:
• ! error
• automatic feeding mode
• double feed detection
skip
• slow mode
• AP mode (DS-575W II)
• Wi-Fi (DS-575W II)
The firmware update has failed and the scanner is in recovery mode.
Try updating the firmware again.
The Wi-Fi and ! error
lights are flashing slowly (DS-
575W II)
An access point settings error (security error) has occurred. Press the
stop button to clear the error, restart the devices you want to connect
to the network, then reconnect to the network.
The Wi-Fi light is flashing
slowly and ! error light is on
(DS-575W II)
The Wi-Fi (white) and
! error lights are flashing
slowly (DS-575W II)
A network connection error has occurred (the date and time have not
been set correctly). Reset the date and time in Web Config.

Epson DS-575W II Specifications

General

Brand	Epson
Model	DS-575W II
Category	Scanner
Language	English