Epson EB-1795F User Manual

Solving Network Problems
165
microwave. Move the interfering device farther away or expand your
wireless bandwidth.
• Reduce the number of connected devices if the connection speed declines.
Solutions When You Cannot Read the NFC Tag
If you are unable to read the NFC tag on your mobile device, try the following
solutions (EB‑1795F/EB‑1785W/EB‑1781W):
• Make sure the Android device is not in sleep mode and that it is not locked.
• Activate the NFC reader on your mobile device.
• Adjust the position of the mobile device so that the NFC reader on the
device is over the center of the NFC tag on the projector.
Solutions When You Cannot Connect Using Screen
Mirroring
If you are unable to connect to the projector using Screen Mirroring, try the
following solutions (EB‑1795F/EB‑1785W):
• Check the projector's settings.
• Select On as the Screen Mirroring setting in the projector's Network
menu.
• Select Off as the Screen Mirroring setting in the projector's Network
menu, and select On again.
• Change the Operation Mode setting and connect again.
s Network > Screen Mirroring Settings > Operation Mode
• Make sure that the no other devices are connected to the projector with
No Interruptions settings.
s Network > Screen Mirroring Settings > Extended > Meeting Mode
• Change the Channel setting according to the wireless LAN environment.
s Network > Screen Mirroring Settings > Extended > Channel
• Check the mobile device's settings.
• Make sure the settings on the mobile device are correct.
• When connecting again immediately after disconnecting, it may take
some time until the connection is established. Reconnect after waiting for
a while.
• Restart the mobile device.
• Once you have connected using Screen Mirroring, the projector
connection information may be recorded on the mobile device. However,
you may not be able to reconnect to the projector from the recorded
information. Select the projector from the list of available devices.
gg Related Links
• "Projector Network Settings - Network Menu" p.125
• "Network Menu - Screen Mirroring Settings" p.126
Solutions When the Image or Sound Contains Static
During Screen Mirroring Connection
If the projected image or sound contains static when connecting using Screen
Mirroring, try the following solutions (EB‑1795F/EB‑1785W):
• Avoid covering the Wi-Fi antenna of the mobile device.
• If you use a Screen Mirroring connection and an internet connection at the
same time, the image may stop or contain noise. Disconnect the internet
connection to expand your wireless bandwidth and improve the connection
speed of the mobile device.
• Make sure the projection contents meet the Screen Mirroring requirements.
• Depending on the settings of the mobile device, the connection may be lost
when the device enters power saving mode. Check the electrical power
saving settings on the mobile device.
• Update to the latest version of the wireless driver or firmware on the mobile
device.
gg Related Links
• "Wireless Network Projection from a Mobile Device (Screen Mirroring)"
p.100

Epson EB-1795F Specifications

General

Matrix size	0.59 \
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Projection distance	1.35 - 1.62 m
Vertical scan range	100 - 120 Hz
Projection technology	3LCD
Contrast ratio (typical)	10000:1
Screen size compatibility	30 - 300 \
Projection distance (tele)	0.8 - 8.2 m
Projection distance (wide)	0.7 - 6.8 m
Projector native resolution	1080p (1920x1080)
Keystone correction, vertical	-30 - 30 °
Keystone correction, horizontal	-20 - 20 °
Projector brightness (economic mode)	1900 ANSI lumens
3D	No
Full HD	Yes
Video processing	10 bit
Video color modes	Blackboard, Cinema, Dynamic, Presentation, sRGB, DICOM simulation mode
Supported video modes	1080p
Analog signal format system	-
Supported graphics resolutions	1920 x 1080 (HD 1080)
Lamp power	214 W
Lamps quantity	1 lamp(s)
Light source type	Lamp
Service life of light source	4000 h
Service life of light source (economic mode)	7000 h
Noise level	39 dB
Country of origin	Philippines
Noise level (economic mode)	30 dB
Focus	Manual
Throw ratio	1.02 - 1.23:1
Focal length range	13.52 - 16.22 mm
Aperture range (F-F)	1.58 - 1.7
USB 2.0 ports quantity	2
S-Video inputs quantity	0
Standard interfaces	HDMI, NFC, USB, VGA, Wireless LAN
USB display function	3 in 1: Image / Mouse / Sound
Sustainability certificates	TCO
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Placement	Ceiling, Desktop
Product type	Standard throw projector
Product color	White, Grey
Market positioning	Business
Cable lock slot type	Kensington
RMS rated power	1 W
Power source	AC
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.34 W
Power consumption (typical)	295 W
Power consumption (economy mode)	208 W
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	5 - 40 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Cables included	AC, HDMI
Bundled software	EasyMP Multi PC Projection
Pallet width	800 mm
Pallet height	150 mm
Pallet length	1200 mm
Pallet weight	0 g
Pallet width (UK)	1000 mm
Quantity per pack	1 pc(s)
Quantity per pallet	70 pc(s)
Quantity per pallet (UK)	84 pc(s)
Quantity per pallet layer	5 pc(s)
Harmonized System (HS) code	85286200
Quantity per pallet layer (UK)	6 pc(s)

Weight and Dimensions

Depth	213 mm
Width	292 mm
Height	44 mm
Weight	1800 g
Package depth	420 mm
Package width	370 mm
Package height	145 mm
Package weight	3730 g