Epson EB-440W User Manual

q
The following screen showing the status of image signals is displayed
when only the image that the projector is currently displaying is
available, or when no image signal can be found. You can select the
input port where the equipment you want to use is connected. If no
operation is performed after about 10 seconds, the screen closes.
Switch to the target image by Remote Control
You can change directly to the target image by pressing the following
buttons on the Remote Control.
Remote Control
A
Each time you press the button, input changes between images from the
Computer1 input port and the Computer2 input port.
B
Each time you press the button, input changes between images from the
Video input port and the S-Video input port.
C
Each time you press the button, input changes between images from the
equipment connected to USB Display and USB(TypeA) port.
D
Changes to the images projected with EasyMP Network Projection. When
you are projecting via Quick Wireless Connection using the optional Quick
Wireless Connection USB Key, pressing this button changes to that image.
Changing the Projected Image
22

Epson EB-440W Specifications

General

Projection technology	LCD
Contrast ratio (typical)	1600:1
Projector native resolution	WXGA (1280x800)
Aspect ratio	16:10
RS-232 ports	1
Dimensions (WxDxH)	369 x 481 x 115 mm
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3500 h
RMS rated power	10 W
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Power consumption (standby)	1 W

Weight and Dimensions

Weight	5700 g