Slideshow Basic Operations
Slideshow lets you play back and project image files stored on USB storage
devices and digital cameras.
This section explains the basic operations for Slideshow.
Although the following steps are explained based on the remote control,
you can perform the same operations from the projector's control panel.
Starting and closing Slideshow
Starting Slideshow
Procedure
A
Change the projected image to USB.
s p.21
B
Connect the USB storage device or digital camera to the
projector.
s p.34
Slideshow starts and the file list screen is displayed.
Exiting Slideshow
Procedure
To close Slideshow, disconnect the USB device from the USB(TypeA)
port on the projector. For a digital camera, hard disk, or other
equipment, turn off the power of the equipment and then
disconnect the equipment.
q
• You can also insert a memory card into a USB card reader and then
connect the reader to the projector. However, some commercially
available card readers may not be compatible with the projector.
• When the following screen (Select drive screen) is displayed, use the
[
][ ] buttons to select the drive you want to use, and then press
the [Enter] button.
• To display the Select drive screen, position the cursor on Select
drive at the top of the file list screen, and then press the [Enter]
button.
Slideshow basic operations
The following describes the procedures for playing and projecting images
using Slideshow.
Procedure
A
[Use the [ ][ ][ ][ ] buttons to position the cursor
on the target file or folder.
Presentations Using Slideshow
29
To Next Page
Loading...
Need help?
General
Weight and Dimensions
