You can change the projected image in the following two ways.
• Changing by Source Search
The projector automatically detects signals being input from connected
equipment, and the image being input from the equipment is projected.
• Changes to the target image.
You can use the Remote Control buttons to change to the target input
port.
Automatically Detect Input Signal and Change the
Projected Image (Source Search)
You can project the target image quickly as input ports with no image
signal being input are ignored when you change by pressing the [Source
Search] button.
A
Computer1
B
Computer2
C
S-Video
D
Video
E
USB Display
F
USB
*
: When the image is from a device connected to the USB(TypeA)
port.
G
LAN: When the projector is connected to a computer via a network,
and images from EasyMP Network Projection are projected.
Skipped when no image signal is being input.
*USB input source indicates that a Slideshow is being played back from a
USB storage device connected to the USB(TypeA) port, or that images are
being projected from the optional Document Camera.
Procedure
When your video equipment is connected, start playback before
beginning this operation.
Using Remote Control Using Control panel
When two or more pieces of equipment are connected, press the [Source
Search] button until the target image is projected.
Changing the Projected Image
21
To Next Page
Loading...
Need help?
General
Weight and Dimensions
