D
Press the [Esc] button to return to the file list screen.
Projecting all image files in a folder in sequence (Slideshow)
You can project the image files in a folder in sequence, one at a time. This
function is called Slideshow. Use the following procedure to run
Slideshow.
q
To change files automatically when you run Slideshow, set Screen
switching time from Option in Slideshow to anything other than No.
The default setting is 3 seconds. s "Image File Display Settings and
Slideshow Operation Settings" p.33
Procedure
A
Start Slideshow. s p.29
The file list screen is displayed.
B
[Use the [ ][ ][ ][ ] buttons to position the cursor
on the folder to be played by Slideshow and press the [Enter]
button.
C
Select Slideshow from the the bottom of the file list screen,
and then press the [Enter] button.
Slideshow starts, and the image files in the folder are automatically
projected in sequence, one at a time.
When the last file is projected, the file list is displayed again
automatically. If you set Continuous Play to On from the Option
screen, projection starts again from the beginning when it reaches the
end.
s "Image File Display Settings and Slideshow Operation
Settings" p.33
You can proceed to the next screen, return to the previous screen, or
stop playback while projecting a Slideshow.
q
If Screen switching time on the Option screen is set to No, files do
not change automatically when you select Play Slideshow. Press the
[Enter] button or the [Page] (Down) button on the remote control to
project the next file.
Presentations Using Slideshow
32
To Next Page
Loading...
Need help?
General
Weight and Dimensions
