Wireless LAN Menu
Settings are enabled when the optional Wireless LAN unit is installed.
Sub-menu Function
Wireless LAN Power
Set this to On when connecting the projector and a computer via a wireless LAN. If you do not want to connect via a wireless LAN, set this to Off to
prevent unauthorized access by others. This is set to On by default.
Connection Mode
Use EasyMP Network Projection to set the mode, how the computer connect to the projector.
Set this to Quick Connection Mode when you want to make a simple wireless connection. Set this to Advanced Connection Mode when you want to
connect to a network system via an access point.
Wireless LAN system
Sets the Wireless LAN system.
SSID
g
Enter an SSID. When an SSID is provided for the wireless LAN system in which the projector will participate, enter the SSID.
You can enter up to 32 single-byte alphanumeric characters.
IP Settings
You can make settings related to the following addresses.
DHCP
g
: Set whether or not (On/Off) to use DHCP. If this is set to On, you cannot set any more addresses.
IP Address
g
: You can input the IP address assigned to the projector. You can input a number from 0 to 255 in each field of the address. However, the
following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask
g
: You can input the subnet mask for the projector. You can input a number from 0 to 255 in each field of the address. However, the
following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
g
: You can input the IP address of the gateway for the projector. You can input a number from 0 to 255 in each field of the address.
However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
List of Functions
83
To Next Page
Loading...
Need help?
General
Weight and Dimensions
