103
2. Press the power button again. (To leave it on, press any other button.)
The projector beeps twice, the laser turns off, and the Status light turns off.
Note: If the Light Source Calibration (EB-770Fi) setting is set to Run Periodically in the
projector's Management menu, light source calibration starts automatically if you turn off the
projector and the following conditions are present:
• 100 hours have passed since the last light source calibration.
• You have used the projector continuously for at least 20 minutes.
3. To transport or store the projector, make sure the On/Standby light is blue (not flashing) and the
Status light is off, then unplug the power cord.
Caution: To avoid damaging the projector or laser, never unplug the power cord when the Status
light is on or flashing.
Parent topic: Using Basic Projector Features
To Next Page
Loading...
