211
• Moving the projector
Note: Move any pen you are not using away from the projection screen while calibrating.
Calibrating Automatically
Calibrating Manually
Parent topic: Using the Interactive Pens
Calibrating Automatically
You do not need the pens or a computer for Auto Calibration.
1. Press the Menu button, select the Pen/Touch menu, and press Enter.
2. Select Auto Calibration and press Enter.
This screen appears:
3. Adjust the image focus, if necessary.
4. Check that the image pattern fits into the projected display, then press Enter to select Yes.
A pattern appears then disappears, and the system is calibrated. If you see a message that
calibration failed, you need to calibrate manually.
The cursor location and pen position should match after calibration. If not, you may need to calibrate
manually.
Parent topic: Pen Calibration
Calibrating Manually
If the cursor location and pen position do not match after auto calibration, you can calibrate manually.
To Next Page
Loading...
