215
Parent topic: Using Finger Touch Interactivity
Performing Touch Unit Setup (Auto)
Adjust the angle of the laser light coming from the Touch Unit so that the Touch Unit can detect the
position of your fingers. Once you have performed Touch Unit Setup, perform touch calibration.
Note: You can purchase a touch unit as an optional accessory or use a compatible touch unit from an
older projector. When using an older model of the touch unit, angle adjustment is not automatic.
Note: Make sure you have calibrated the pens, installed the Touch Unit, and turned the Touch Unit on
before performing setup. See the online Installation Guide for Touch Unit installation information and
click the link below for pen calibration instructions.
1. Press the Menu button, select the Installation menu, and press Enter.
2. Select Touch Unit and press Enter.
3. Select Touch Unit Setup (Auto) and press Enter.
The following screen appears:
To Next Page
Loading...
