253
2. To move the toolbar, use the pen or your finger to drag it to the desired location.
3. To minimize or expand the toolbar, select the icon.
Parent topic: Using BrightLink Without a Computer
Splitting the Projected Image with Whiteboard Mode
When projecting from an input source in Annotation mode, you can split the screen and open a
whiteboard page to interact with simultaneously.
1. Turn on the projector and project an image, if necessary.
2. Select the Whiteboard icon on the left side of the toolbar.
You see the whiteboard display on the screen.
3. To increase either the whiteboard or the projected image, drag the white part of the center divider to
the appropriate side.
Note: To enlarge either side to fit the entire screen, drag the white part of the center divider fully to
the desired edge of the screen.
4. To swap the projected image and whiteboard from left to right, select the at the bottom of the
center divider.
You cannot perform the following operations during split screen projection:
• E-Zoom
To Next Page
Loading...
