217
8. Press Enter on the remote control or control panel to begin the auto adjustment.
9. When adjustments are complete, remove the markers.
Note: If auto adjustment fails, follow the instructions on the screen to manually adjust the angle of
the laser and run Touch Unit Setup (Auto) again or run Touch Unit Setup (Manual).
10. Touch each of the four yellow circles on the screen and verify that the gray touch indicator appears
in the correct position.
Note: Finger touch operations may not function correctly if you are wearing bandages, artificial nails,
nail polish, or anything else that may obstruct your fingers.
If the gray indicators do not appear where you touched the screen, you need to manually adjust the
touch unit alignment.
11. Select Up using the remote control or control panel and press Enter.
To Next Page
Loading...
