The projector is provided with the following four indicators that indicate the operating status of the projector.
A
Power indicator Indicates the operating status.
Standby condition
In this status, you can start projecting by pressing the [
] button on the remote control, or the [t] button
on the control panel.
Preparing for network monitoring or cool down in progress
All buttons are disabled while the indicator is flashing.
Warming up
Warm-up time is about 30 seconds. After warm-up is complete, the indicator stops flashing.
The [t] button is disabled during warm-up.
Projecting
B
Lamp indicator Indicates the projection lamp status.
C
Temp indicator Indicates the internal temperature status.
D
Filter indicator Indicates the air filter status.
Reading the Indicators
16
To Next Page
Loading...
