Epson EB-G6800 - Multi-Projection; Preparing the Projector; Work Flow

Aspect Ratio of Input Signal
16:10 16:9 4:3
Native
*
* The image may differ depending on the resolution of the input signal.
Multi-Projection
Preparing the Projector
• Set the ID to the projector.
Press [Menu] button > Extended > Multi-Projection > Projector ID
When operating the projector, (1) set the remote control [ID] switch to
On, (2) hold down the [ID] button, (3) and then press the same number
button as the ID of the projector.
To check the projector's ID, press the [Help] button while holding
the [ID] button on the remote control to display the ID on the screen.
• Adjust the position of the projected image by using the direction of the
projector and lens shift.
s
p.20
• Set Color Mode to Multi-Projection with the [Color Mode] button on
the remote control (set to 3D Multi-Projection for 3D images).
a
• We recommend making settings at least 30 minutes after you start
the projection, because images are not stable right after turning on
the projector.
• If the Geometric Correction value is large, when overlapping
images, it may be difficult to match the position of the images.
• Correction is easier if you use the image in dot by dot format, that
can be displayed without being enlarged or reduced.
Work flow
(1)
(2)
(3)
(4)
(1) Correct small gaps in position when matching projected images s "(1) Point
Correction " p.63
(2) Adjust the differences in brightness for each projector lamp s "(2) Brightness
Adjustment." p.64
(3) Fine tune overlapping areas to make seamless screen. s "(3) Edge Blending"
p.64
(4) Correct the color balance of the projected images s "(4) Multi-screen" p.67
(1) Point Correction
See p.59.
Projecting Images
63